G is less concrete anchor insulation plate of gas concrete for mounting in kullanılır.kalitel dowel selection system Angle out very önemlidir.yalıt sheet back to the application that is used to detect surface mechanically transform to undergoes not plastic finished or preferably mechanical fastening element with a minimum value of 0.20 kN tensile strength based polymit. Aerated concrete dowel should enter the application surface by at least 9 cm excluding the insulation material. The working principle of aerated concrete dowel is drilled with an 8mm drill. 11 independent nails do not change the hole anchor by penetrating into the hole while entering the hole. When the nail is inserted, 11 independent nails sink into the gas concrete separately. In this way, a great adherence is achieved on gas concrete with poor adherence. The product should enter the gas concrete with a minimum of 9 cm. The drill diameter must be 8 cm. In EPS or XPS boards, gas concrete dowel with plastic nails, in rockwool plates, gas concrete dowel with steel nails, insulation thickness is 8 cm. aerated concrete dowel with screw on the slabs above li should be used. Dowel length selection should be chosen as insulation thickness + 10 cm, wall crookedness should be considered.