Homepage ›› Companies ›› Neset Halit Cardak ›› Tipper Projects

Neset Halit Cardak

Adres: ALINTERİ BULVARI 33 F

Tel 1: 0 (312) 310 53-53

Faks: 0 (312) 310 95 14

Email 1: info@tezelmuhendislik.com

Email 2: nhcardak@hotmail.com

Web: http://www.tezelmuhendislik.com/

Tipper Projects

Tipper Projects

Superstructure Renovation Projects ( AITM )
According to the nature of the load and work in vehicles with a complete and completed vehicle certificate; tipper case wood
chassis, tank, vacuum truck, fire engine, road sweeping equipment, crane, etc. superstructures will comply with Annex VIII. Basis
If the vehicle's system type-approvals are no longer valid due to modification, the amendment shall be included in Annex VII.
Compliance with the given substances should be reported. In addition, side protection in accordance with Annex VII point 1.42
frame will be found.
For example: The hopper behind vehicles such as concrete pumps and garbage trucks is protected from rear-end collisions.
protection must comply with Directive 70/221/EC. In accordance with the requirements of the 76/756/EC Regulation of the lighting installation
compliance must be reported by the authorized engineer.
In LPG tanker modification projects, the (material, welding, pressure and
sealing) test reports and specifying the tank serial numbers (separately for each tank)
A copy of each report must be attached to the renovation project.
LPG tanker installation projects without test reports will not be approved.
Liquid fill rate in LPG tankers should not exceed 80%. In fuel tankers, this rate is 90% and
in other liquids it should be evaluated as 95%.
Superstructures with Hydraulic Parts
Technical File Conformity Letter, Commitment and Contract for the projects of superstructure modifications with hydraulic components.
CE Declaration of Conformity will be required. In case the superstructure is imported, a CE declaration of conformity will be sought. NS
If there is a document and/or report received from the notified body in the projects where the mark is in question, the technical
file conformity letter is not searched.
Issues related to fire engines and road sweepers:
While preparing the Conformity Documents, next to the definition of "Fire Truck", Escort Vehicle, Foam Transport Vehicle
A description of the vehicle in accordance with the truth must be added.
Vehicles and similar products covered by the TS EN 1846 "Fire Fighting and Rescue Vehicles" standard
fire trucks are covered by the Machinery Safety Regulation. Regarding the superstructure with hydraulic parts
The procedures shall also apply to fire fighting and rescue vehicles.
For fire brigade and road sweeping vehicles, specified in the list published by the Ministry of Industry and Trade.
compliance with regulations and/or regulations is sought.
4.8.1. Individual tops to be made on vehicles of category N and O with an incomplete type-approval certificate.
In the buildings, the conditions sought in article 4.8 must be met.
According to article 128.j of the Highway Traffic Regulation, only for the purpose of carrying indivisible loads,
To carry non-divisible loads to 5-axle motor vehicles that have been type-approved to be put on the road with special permission.
Approval of suitable superstructure projects is appropriate provided that the exceptional provision of the legislation is specified. This
In this context, it is appropriate to evaluate the tanker tipper body within the scope of carrying indivisible loads.
not available. In addition, tankers suitable for the transportation of pourable and fissile cargoes of the said vehicles,
damper etc. superstructure projects will not be approved by our institute.
Inspection and approval of trailer and semi-trailer modification projects; specified in TS 4930 Article 2.2.6.
conditions should be sought and the Maximum Loaded Qatar Weight value should be written in the Certificate of Conformity.

Get Info
Araç üstü Ekipman İmalatçıları